Personally I think the new hardened saws are superior to any old sharpened saw. The so called "japanese" saws that cut on the reverse are brilliant for accurate stuff. I must have about 10 different handsaws and the lot didnt cost much at all.
- Thread starter julianthegypsy
- Start date
brightspark
Member
- Messages
- 41,235
- Location
- yarm stockton on tees
re sharpen able old saws or induction hardened throwaway saws are both good only providing there both sharp 
times money so the choice is obvious
times money so the choice is obvious
pedrobedro
Man at Matalan
- Messages
- 13,103
- Location
- CX near Chesterfield
not when saws only cost 6 quid
That's dear I paid £3.95 for the last hardpoint saw I bought. I bought a normal saw for under £10, Tyzack make and it's decent.
brightspark
Member
- Messages
- 41,235
- Location
- yarm stockton on tees
but what make hard point, there's saws and better saws
pedrobedro
Man at Matalan
- Messages
- 13,103
- Location
- CX near Chesterfield
but what make hard point, there's saws and better saws
It cuts just as good as the Stanley jetcut it replaced which had lost half its teeth through abuse so I'm happy and about £6 in pocket
Wendelspanswick
Member
- Messages
- 6,486
I use the Spear & Jackson Predator saws, the red handled one (8 TPI I think), they get used first for accurate cutting, then once they start to get knackered they either get used for pallets/gash timber or aircrete blocks.
