Work bench vices

[Jacktegla]

I e just built a larger work bench and I’ve got a few vices and can’t work out which would be best to put on it. I originally had the small one on my old bench because I could put soft jaws on it but I’m not sure what to do now. Any ideas ps does anyone know if you can get larger soft jaws and normal new jaws for the big vice

 

[The_Yellow_Ardvark]

A small start.
But a nice start.

 

[Arclikeharrypotter]

Middle one would be my choice, good size to it and also quick release jaw! Easy enough to make some soft jaws for to.

 

[frank horton]

sorry, but not enough junk on the bench yet...........hahaha........
which vice.?....go for the brute I would....

 

[eLuSiVeMiTe]

I'd put the two larger either end of the bench.
The smaller I'd mount on a movable stool to use outside etc

 

[Maker]

I would (And do ) have the No.6

Keep the smaller one somewhere handy and sell the QR in my opinion.

 

[eLuSiVeMiTe]

I would (And do ) have the No.6

Keep the smaller one somewhere handy and sell the QR in my opinion.

Have two no 6 lined up on my bench. Can hold long bits in both vice then.

 

[Tom O]

I’d put the big one the others can fit into it!

 

[waddycall]

Choose the one which suits you height wise for sawing and filing

 

[mrsbruce]

I will solve your quandary. Send the middle one to me, I shall take care of it.

 

[The_Yellow_Ardvark]

I will solve your quandary. Send the middle one to me, I shall take care of it.

Bad Lady.
You have already said to some, you need not more vices.
In case it starts something.


So.
To help you out and others.
I will have to remove all if them.

I all ready have a vice addiction. I will suffer for you all.

 

[Wallace]

Choose the one which suits you height wise for sawing and filing

This for any of the vices. I set my bench height according to the vice and mine is a little tall now I swapped the vice out for a larger one. A duck board would bring it back in line but I would probably trip over it now I’m old!