Perry Owens
Member
- Messages
- 763
Anyone have experience of these benders?
At present I form 70 degree bends in 50 x 6mm bar like this
using the hacksaw/bash/weld method but one of these would save me some trouble if it makes tight radius bends in 6mm bar. The spec sheet says it will but the video clip only shows it bending about 3mm bar.
At present I form 70 degree bends in 50 x 6mm bar like this
using the hacksaw/bash/weld method but one of these would save me some trouble if it makes tight radius bends in 6mm bar. The spec sheet says it will but the video clip only shows it bending about 3mm bar.