Iv been having a problem with my 215 amp portamig over the last few weeks.
Its been it seems to run wire fine for a few seconds and then just starts slipping.
Iv tried new wire, new liner etc but no good. I think the guide bearing may be gone so I set about changing that.
This is all besides the point really, because as I was fiddling with the motor, i think I may have pulled this wire from its connection as the machine will now no longer feed wire.
Anyone any idea where this should be connected? I cant find a wiring diagram for the machine anywhere
Its been it seems to run wire fine for a few seconds and then just starts slipping.
Iv tried new wire, new liner etc but no good. I think the guide bearing may be gone so I set about changing that.
This is all besides the point really, because as I was fiddling with the motor, i think I may have pulled this wire from its connection as the machine will now no longer feed wire.
Anyone any idea where this should be connected? I cant find a wiring diagram for the machine anywhere