Hi i'm new to this forum, I found it while searching google.
Thinking of making a wire feeder that I can keep setup for aluminium wire. Was just wondering if there are any controllers available or DIY kits? Something basic that just controls motor speed would be good.
I was also thinking of adding pre and post flow gas settings as these would help when it comes to welding aluminium. Also wire inch and gas purge.
Any suggestions would be good.
Thanks
Thinking of making a wire feeder that I can keep setup for aluminium wire. Was just wondering if there are any controllers available or DIY kits? Something basic that just controls motor speed would be good.
I was also thinking of adding pre and post flow gas settings as these would help when it comes to welding aluminium. Also wire inch and gas purge.
Any suggestions would be good.
Thanks