DaveM-sport
Member
- Messages
- 19
Looking to get a Murex in the next few days but can't decide on which one...
Found a good Transmig 500 for around the 1000 mark which seems like great value but the fact that it only goes down to 50amp restricts some of the work I'd be doing so would need to get another smaller plant for that.
Also looking at the 280-3, 300C and 350C plants. Although a good bit more in price, the 300 and 350C offer a pretty decent range.
Was thinking about the single phase 251 but afraid it might not be strong enough for some stuff.
Work I'd be doing would be from car body work such as repairs and seam-welding etc, roll-cages and other fabrication work to things like agricultural stuff such as excavator buckets and heavy stuff like that.
So I suppose in an ideal world, I'd be looking for a welder do be able to do down to car body sheet metal and up to 15mm or any more is always welcome
Suppose I'm really asking too much and will more than likely be best getting maybe the 500 model and a small little single phase plant for car body work?
Found a good Transmig 500 for around the 1000 mark which seems like great value but the fact that it only goes down to 50amp restricts some of the work I'd be doing so would need to get another smaller plant for that.
Also looking at the 280-3, 300C and 350C plants. Although a good bit more in price, the 300 and 350C offer a pretty decent range.
Was thinking about the single phase 251 but afraid it might not be strong enough for some stuff.
Work I'd be doing would be from car body work such as repairs and seam-welding etc, roll-cages and other fabrication work to things like agricultural stuff such as excavator buckets and heavy stuff like that.
So I suppose in an ideal world, I'd be looking for a welder do be able to do down to car body sheet metal and up to 15mm or any more is always welcome
Suppose I'm really asking too much and will more than likely be best getting maybe the 500 model and a small little single phase plant for car body work?