Hi all,
This is my first post, just bought myself a Lorch Handy tig mainly based on the glowing recommendation from Brad.
Also a newbe to tig, been doing lots of reading up on the subject especially regarding the different rods available. Will mainly be working on fairy thin materials which will require thin rods but it seems difficult to buy the better rods e.g Esab in say 1 or 1.2mm.
Have been looking for some 4047 in 2.4mm and 309L in 1.2mm without much success, Siff seem more widely available but have been advised to stick with Esab or Bohler for very best results.
Thoughts and recommendations regarding where to buy would be much appreciated, great site, very informative.
This is my first post, just bought myself a Lorch Handy tig mainly based on the glowing recommendation from Brad.
Also a newbe to tig, been doing lots of reading up on the subject especially regarding the different rods available. Will mainly be working on fairy thin materials which will require thin rods but it seems difficult to buy the better rods e.g Esab in say 1 or 1.2mm.
Have been looking for some 4047 in 2.4mm and 309L in 1.2mm without much success, Siff seem more widely available but have been advised to stick with Esab or Bohler for very best results.
Thoughts and recommendations regarding where to buy would be much appreciated, great site, very informative.