Hi folks, im new to this forum but not to welding or electrics.
My welder is a SIP 130 Turbo Migmate & it was dropped which resulted in the power cable being wrenched out further than it should be causing the connections to the power switch to disconnect. Now all connections are pretty obvious to me except this black wire, the only spade terminal i can see that is spare is the top connection on the HI/LOW switch on the front. Can anyone shed any light as to where this connector should go? I dont wanna risk switching it on and frying anything.
Sorry if the pictures a little large i dunno how to resize it.
Cheers for any help Andy.
My welder is a SIP 130 Turbo Migmate & it was dropped which resulted in the power cable being wrenched out further than it should be causing the connections to the power switch to disconnect. Now all connections are pretty obvious to me except this black wire, the only spade terminal i can see that is spare is the top connection on the HI/LOW switch on the front. Can anyone shed any light as to where this connector should go? I dont wanna risk switching it on and frying anything.
Sorry if the pictures a little large i dunno how to resize it.
Cheers for any help Andy.