britishmonkey
New Member
- Messages
- 1
Iv bought a old trailer which i am in the process of sorting out but i have issues with the wheel bearing in one hub and wondered if anybody could help.
The outer bearing collapsed in hub 1 on the trailer. I orded in a new bearing L4469. And race l4410. However iv noticed when i put in the new race it sat too far into the hub therefore when i put the bearing in and tightned it up the drum was still loose on the hub.
I took off drums 2,3 & 4 checked the bearing numbers and were all the same as above. I cleaned them all up and looking inside were the bearibg race seats there is a thickness of around 8mm. On drum 1 the seat is only around 2mm.am i missing some type of washer or spacer or is it the wrong drum? All 4 drums are marked BBTF
Anybody have any idea what the make of tbe units are? The pcd is 140mm bore diameter is 95mm
Thanks for your help.
The outer bearing collapsed in hub 1 on the trailer. I orded in a new bearing L4469. And race l4410. However iv noticed when i put in the new race it sat too far into the hub therefore when i put the bearing in and tightned it up the drum was still loose on the hub.
I took off drums 2,3 & 4 checked the bearing numbers and were all the same as above. I cleaned them all up and looking inside were the bearibg race seats there is a thickness of around 8mm. On drum 1 the seat is only around 2mm.am i missing some type of washer or spacer or is it the wrong drum? All 4 drums are marked BBTF
Anybody have any idea what the make of tbe units are? The pcd is 140mm bore diameter is 95mm
Thanks for your help.
