Hi, I spent all of Sunday cutting out floor panals to a car and it took about 6 hours to only do 1/2, I ran out of discs (I used about 10) and still have to go back another week now. Due to this being a pain in the bakside I decided I might buy a cheap plasma cutter, I have no idea about them, how they work etc but it just seems like a much easier option.
I'm looking to spend around £300 on a cutter and setup (any saftey equiptment needed). I mostly need it for steel between 0.8mm and 1.5mm but obviously the more ii can use it for the better for any possible future need .
Please point me in the right direction for information, advice, products and technique. I know this is a lot and I'd have a good google before asking first but I, stuck at work right now so that's not a really viable option.
Thanks
Liam
I'm looking to spend around £300 on a cutter and setup (any saftey equiptment needed). I mostly need it for steel between 0.8mm and 1.5mm but obviously the more ii can use it for the better for any possible future need .
Please point me in the right direction for information, advice, products and technique. I know this is a lot and I'd have a good google before asking first but I, stuck at work right now so that's not a really viable option.
Thanks
Liam