I've been learning to weld for the last few months and have been able to stick new metal where there was once a rusted hole.
I've always been slightly concerned about penetration though, but have never really been able to find an example of what is a good level.
Would someone be kind enough to show a couple of examples of what level of penetration I should be looking to achieve with butt welds? I'm working on car sills at the moment and < 3mm steel
Thank you.
Sincilite
I've always been slightly concerned about penetration though, but have never really been able to find an example of what is a good level.
Would someone be kind enough to show a couple of examples of what level of penetration I should be looking to achieve with butt welds? I'm working on car sills at the moment and < 3mm steel
Thank you.
Sincilite