Little Jerry
Member
- Messages
- 140
- Location
- Australia
Hopefully not a too ignorant question but:
If I wanted to restore a crease line on a fold of a low crown auto panel that has been dented - is there a specialised dolly type tool I can get? I have a standard hammer and dolly type set but don't think the edge on the wedge dolly is sharp enough?
Just curious what the correct dolly / backing tool to use would be?
Regards
Adam
If I wanted to restore a crease line on a fold of a low crown auto panel that has been dented - is there a specialised dolly type tool I can get? I have a standard hammer and dolly type set but don't think the edge on the wedge dolly is sharp enough?
Just curious what the correct dolly / backing tool to use would be?
Regards
Adam