I made a start on the trike frame today, the joint seems strong, jammed one end under the shed and pulled like a good 'un! As ever all advice gratefully received.
40x40x3 box, about 90amps, 1.6 A15, 1.6 Thor, 8 lpm.
Did I get enough filler on this weld?
Opposite side.
Outer edge (like a knee)
This is the worst, (back of knee) I know I did not get enough gas on it, and it looks as if I missed a bit, but that is the way the picture came out, honest. It is a bit of a wobbly weld though. Should I leave it, or, grind it off and do it again?
Thanks for looking
Rich
40x40x3 box, about 90amps, 1.6 A15, 1.6 Thor, 8 lpm.
Did I get enough filler on this weld?
Opposite side.
Outer edge (like a knee)
This is the worst, (back of knee) I know I did not get enough gas on it, and it looks as if I missed a bit, but that is the way the picture came out, honest. It is a bit of a wobbly weld though. Should I leave it, or, grind it off and do it again?
Thanks for looking
Rich