Hi,
Thought I had it licked on my practice sheets and moved on to the car. The welds went on ok whilst working directly in front but have moved to an underbody section on my back and my welds are following gravity and forming drips.
I'm still working at a 45 degree angle and am trying to direct the weld with as drag motion but failing.
I'm also heating the panel too much as I went back to fix bits i've missed due to these drips and heated the area too much and had wax dripping down from elsewhere in the panel (I had cleaned as best as I could where I can reach. I'd like to avoid this next time but I've got it finished now but it's looks messy before ground back and I had 1 pin hole I I wasn't able to fix due the wax dripping around the area.
Anytips?
Thought I had it licked on my practice sheets and moved on to the car. The welds went on ok whilst working directly in front but have moved to an underbody section on my back and my welds are following gravity and forming drips.
I'm still working at a 45 degree angle and am trying to direct the weld with as drag motion but failing.
I'm also heating the panel too much as I went back to fix bits i've missed due to these drips and heated the area too much and had wax dripping down from elsewhere in the panel (I had cleaned as best as I could where I can reach. I'd like to avoid this next time but I've got it finished now but it's looks messy before ground back and I had 1 pin hole I I wasn't able to fix due the wax dripping around the area.
Anytips?