I have decided to bite the bullet and begin work on the body of my VWtype 25. I have acquired a second hand Sip (I know, I know) Migmate 105 Turbo with virtually no use. I am a complete newbie to this , so expect loads of dumb questions and cock ups!
I am going to start on the rear nearside corner. A really small simple panel.
I have been told that all MOT welding must be seam welded, but this panel was only spot welded at the factory and doesn't seem to be structural . Is that right. Also, when seam welding on a small overlap. Does it need both sides, inside and out welding.
Told you there would some dumb questions.
The panels involved :
I am going to start on the rear nearside corner. A really small simple panel.
I have been told that all MOT welding must be seam welded, but this panel was only spot welded at the factory and doesn't seem to be structural . Is that right. Also, when seam welding on a small overlap. Does it need both sides, inside and out welding.
Told you there would some dumb questions.
The panels involved :