Onoff
In the land of the unfinished project I am King!
- Messages
- 10,162
- Location
- Sevenoaks, UK
Building my sliding gates:
This side is fine:
Doing the other pillar now and I've found I put the post in 25mm too high originally.
I need to lop off this horizontal section and move it 25mm lower:
All I have here is 3.2mm Superon 6013 rods.
I've never welded vertically. Start at the bottom, small circles moving up or side to side holding on the edges before moving upward, rod held downward, just off horizontal?
Any tips?
Cheers
This side is fine:
Doing the other pillar now and I've found I put the post in 25mm too high originally.
I need to lop off this horizontal section and move it 25mm lower:
All I have here is 3.2mm Superon 6013 rods.
I've never welded vertically. Start at the bottom, small circles moving up or side to side holding on the edges before moving upward, rod held downward, just off horizontal?
Any tips?
Cheers