brightspark
Member
- Messages
- 41,574
- Location
- yarm stockton on tees

It’s all about understanding your loads and charging accordingly. Fast charging is not always good for the batteries. I also use inductive charging for phones, it’s slower, generates less heat and doesn’t wear the USB-C connector.
But laptops? LMAO, 45 watts indeed. That’s OK for a tablet but not a proper laptop. My Lenovo has a 135w PSU with it and on the occasions where I have had to work in the car, the cigar lighter thingy I have, which is 95w, will just about keep it alive with a gradual discharge. Yes, it’s a workstation grade machine but even my old one had a 85w PSU.
These sockets look cool but what was wrong with the correct charger for the device?
there doable if the 25mm boxes are set back about an eight of an inch and its a swopi guess this is fairly obvious but the back boxes with often need to be deeper maybe 35mm not 25mm

i used to fast charge my galaxy s22 all the time...got to the point the battery would only last around 4 hours on a full charge while sat idle.
since buying my pixel 10 i notice if i have an alarm set for the morning it will charge slowly, just quick enough that it hits 100% just before the alarm sounds, it tells you it is for battery health maintenance and seems to work as i can run all day watching youtube in the crane, use google maps to get home and sit browsing at home and still rarely gets below 20% by the time i pulg it in
its a pain in the **** having to disconect for testingYou've got to drop the test voltage to 250V, disconnect them or short L&N when dead testing.
unless you have just rewired or wired the place and put them on after the testYes. I saw it mentioned that (some?) MK grid switch module power the USB charger via a switch operated when a USB plug is plugged in.If you install one of these faceplates does it mean that the built in usb charger is always on?






