spannermanager
New Member
- Messages
- 3
Gentlemen, my first post here, and its an asker, rather than a teller....
my Murex 130 has been an absolute gem, it was new in '86, but i knew eventualy i would need some expert advice, hence i know ive come to the right place
mid job yesterday it blew the plug fuse, splatter down the shroud from an upside down repair, which i replaced, now it runs wire and gas for a few seconds then blows again , but it doesnt spark the wire , the relay pulls in fine, just no welding function, ive checked the welding earth back to the casing anchor and all the small earth connections, on/off switch lighs up, nothing looks or smells burnt, looks remarkably good in fact after 30 odd years any ideas would be a great help to free up my log jammed w/shop regards Johnny.
my Murex 130 has been an absolute gem, it was new in '86, but i knew eventualy i would need some expert advice, hence i know ive come to the right place
mid job yesterday it blew the plug fuse, splatter down the shroud from an upside down repair, which i replaced, now it runs wire and gas for a few seconds then blows again , but it doesnt spark the wire , the relay pulls in fine, just no welding function, ive checked the welding earth back to the casing anchor and all the small earth connections, on/off switch lighs up, nothing looks or smells burnt, looks remarkably good in fact after 30 odd years any ideas would be a great help to free up my log jammed w/shop regards Johnny.