So after some advice. I have made a frame up using some angle iron at 3mm. The frame is going to be a table but to finish it off im after some sheet metal for the top surface.
Would I get away with a 2mm top sheet ? Or would the welder burn through it? Im using 2.5mm rods at the min. I would be welding it onto the 3mm angle iron so the total thickness would be 5mm.
Any advice would be great !
Would I get away with a 2mm top sheet ? Or would the welder burn through it? Im using 2.5mm rods at the min. I would be welding it onto the 3mm angle iron so the total thickness would be 5mm.
Any advice would be great !