Topleymike
Member
- Messages
- 34
- Location
- Shropshire England
I recently purchased an AJH Bison 12" pedestal grinder, in three phase,saw it working in situ when I collected it. To run it here I have a static three phase converter a Motorun the same as some body on here was selling the other day. It worked fine to start with but now it starts but before it reaches full speed it shuts off. The converter is fine it will run it if you connect the motor direct and also as it did before,run my linisher ok. Is it likely to be the thermal overload or the coil in the starter? I would like to use the sme type of starter if poss because it is recessed into the front of the machine and wondered about suppliers it is an elmic.