Agroshield
Member
- Messages
- 4,732
As thread title, I am looking for a retaining clip for a 6mm dia. shaft that can be tethered so it is not lost or dropped.
A standard R-clip, which can be had in 1mm, 1.2mm and 1.5mm dia. is open ended so could slip off the tether.
A double coil R-clip would do, but only comes in 2mm min. dia. for a 10mm shaft.
Lynch pins do not go small enough (about 4.5mm min. dia.).
Any suggestions welcomed.
Thanks.
A standard R-clip, which can be had in 1mm, 1.2mm and 1.5mm dia. is open ended so could slip off the tether.
A double coil R-clip would do, but only comes in 2mm min. dia. for a 10mm shaft.
Lynch pins do not go small enough (about 4.5mm min. dia.).
Any suggestions welcomed.
Thanks.