leohynes12345
New Member
- Messages
- 1
Hi All,
I'm new to this forum, hope im in the right place, forgive me if not. I'm looking for some help if possible.
I need to replace the power selector switch (Bremas) on a telwin master mig 261/2 welder for my uncle. The switch has buned out. The switch details are as follows:
Bremas Switch no. - CS0258160
Series A 2500
AC1 32A-660V
AC 23/AC3
220v – 6.6kw
280v – 11kw
500v -13.5kw
600v -17kw
From what I can gather it is a 12 position, 25A switch with a schema no 8160 with 16 contacts.
The schemas no. 8160 is the internal contact setup of the switch (I think!)
I have tried searching online but they seem to be like gold dust. I have emailed "Bremas" twice but no reply yet.
Does anybody know where I could get a replacement or can you suggest an alternative. Your help would be much appreciated.
I have attached some photos...
Thank you for any help in the right direction,
Regard,
Leo.
I'm new to this forum, hope im in the right place, forgive me if not. I'm looking for some help if possible.
I need to replace the power selector switch (Bremas) on a telwin master mig 261/2 welder for my uncle. The switch has buned out. The switch details are as follows:
Bremas Switch no. - CS0258160
Series A 2500
AC1 32A-660V
AC 23/AC3
220v – 6.6kw
280v – 11kw
500v -13.5kw
600v -17kw
From what I can gather it is a 12 position, 25A switch with a schema no 8160 with 16 contacts.
The schemas no. 8160 is the internal contact setup of the switch (I think!)
I have tried searching online but they seem to be like gold dust. I have emailed "Bremas" twice but no reply yet.
Does anybody know where I could get a replacement or can you suggest an alternative. Your help would be much appreciated.
I have attached some photos...
Thank you for any help in the right direction,
Regard,
Leo.