8ob
Forum Supporter
- Messages
- 13,195
- Location
- Nescient in the vale
Not so much about the table or controls but the plasma machine itself. Getting close to bolting the table etc together and have some help on the control system but Dont really want to tie up the plasma I use now on the table so am looking for something suitable that will adapt to table use and cut up to 12mm plate. Not sure how all this works with duty cycles/cutting time but dont want a machine that sets off on a program and conks out halfay through a job untill it cools off.
So table only takes half a sheet, 12mm would be the maximum cut, three phase not a problem, torch needs to be the sort used on a table and if possible a model that is reasonably priced on consumables.
Have at it, what do I need
Bob
So table only takes half a sheet, 12mm would be the maximum cut, three phase not a problem, torch needs to be the sort used on a table and if possible a model that is reasonably priced on consumables.
Have at it, what do I need
Bob