Kram
Member
- Messages
- 6,229
- Location
- Sussex
I was drilling 12mm with the drill chuck and it decided to spin. I always check its clean before inserting tool. Tapped drill chuck in harder and continued and it did not spin again but it was hard to remove, with a burr or friction weld.
I have cleaned up the drill taper with a file but the tailstock does not feel right, there is a burr inside.
I have a pair of cheap mt2 reamers of unknown quality, I am wondering if I should try them, might make it worse?
I have cleaned up the drill taper with a file but the tailstock does not feel right, there is a burr inside.
I have a pair of cheap mt2 reamers of unknown quality, I am wondering if I should try them, might make it worse?