I've just converted my Sealey Supermig 160 to Eurotorch (thanks to a nice gas solenoid from member weldequip. Started off really nice but after a few minutes welding the current seemed to go right down. I'm running 0.8 wire with straight CO2 on around 6mm mild steel. I've run with essentially the same setup for ages with no problems. Current setting is Max (position 4) and wire speed around 6 - 7.
This doesn't seem to be an overheat problem. I've checked all connections external and internal. It feels as if I'm on setting 3 instead of 4.
Any suggestions/bright ideas/previous experience of this?
This doesn't seem to be an overheat problem. I've checked all connections external and internal. It feels as if I'm on setting 3 instead of 4.
Any suggestions/bright ideas/previous experience of this?