selectedgrub
Member
- Messages
- 3,598
- Location
- New Zealand
Harley Davidson.
Alot of people wear his shirts but no one listens to his music.
Alot of people wear his shirts but no one listens to his music.
- Thread starter God mode restorations
- Start date
Erie Fred
Member
- Messages
- 6,861
- Location
- Erie, Pa USofA
First time at CNC plasma cutting aluminum, had some very old 1/8" thick diamond plate
from a firetruck I scrapped.
IIRC 100 amps at 40 IPM.
I put the water in the tank up tight to the bottom of the plate, worked pretty cleanly.
Blasted all the parts in the cabinet, as they were very oxidized, and the back was pitted badly.
Also tried out my new HF spool gun on the little 170 amp lunchbox welder.
from a firetruck I scrapped.
IIRC 100 amps at 40 IPM.
I put the water in the tank up tight to the bottom of the plate, worked pretty cleanly.
Blasted all the parts in the cabinet, as they were very oxidized, and the back was pitted badly.
Also tried out my new HF spool gun on the little 170 amp lunchbox welder.
Bullet2012
Member
- Messages
- 5,488
- Location
- on average about 200 miles from the ISS.
Is this another of your creations?Harley Davidson.
Alot of people wear his shirts but no one listens to his music.
If so can’t wait to see the finished article
