Looks lovely( where do you live)?
- Thread starter God mode restorations
- Start date
rory1
Member
- Messages
- 1,201
- Location
- Macclesfield
Yeah, the body I removed was all made from thin pressings, the new one is 50x150 rhs around the outside with 50x100 unequal angle bearers and a 3mmfloor..... somewhat heavier than the original
doubleboost
Member
- Messages
- 3,848
- Location
- Newcastle upon Tyne England
doubleboost
Member
- Messages
- 3,848
- Location
- Newcastle upon Tyne England
doubleboost
Member
- Messages
- 3,848
- Location
- Newcastle upon Tyne England
Yes but not with the wagon it is not old enough this year lol but i will be there
doubleboost
Member
- Messages
- 3,848
- Location
- Newcastle upon Tyne England
I will be on the B5 Fowler doing a bit of firing and video
No but Fraser went pop and then set up again that's why there trading name was Fraser of Feterangus 19??
Scruffywelder
Member
- Messages
- 488
- Location
- Dumfries & Galloway, Scotland
Still didn't paint them much though!
I think they ceased trading about 1999. FIL has a 6 ton Fraser grain trailer from the early 90's and BIL had an 8 ton silage trailer from about the time they shut down. Better designed than most but went rusty very rapidly.
Last I heard the Fraser brand was being sold on by Botex/European Forestry Machinery/Jas. P. Wilson (same company/group) of Dalbeattie:
http://www.fwi.co.uk/machinery/fraser-equipment-on-verge-of-a-comeback.htm
doubleboost
Member
- Messages
- 3,848
- Location
- Newcastle upon Tyne England
Land Rover Bits
@doubleboost I take it that that is on the RTec ??
doubleboost
Member
- Messages
- 3,848
- Location
- Newcastle upon Tyne England
Yes 11 mill plate
There should be some video posted later
There should be some video posted later
The_Yellow_Ardvark
https://www.death-clock.org/
- Messages
- 20,084
- Location
- Going Away.
Nothing much, just 4 Hickory handles. I was visiting a friend who has a copy Lathe. Well, a lathe with a copy attachment on it.
Yes, I had fun, Yes I will visit them again.
No I will not do this again.
Why? The cost of the blanks was more than I could buy ready made handles from a local, but expensive hardware shop.
Plus my friend does not have good coffee.
Lessoned learnt.
wyn
Member
- Messages
- 3,707
- Location
- Cardiff
Made this "spare wheel protector" the other day.
It's pretty much the same as ones you can buy. It's supposed to stop the cable that holds the wheel in place being cut and the wheel nicked.
I hadn't bothered before as it only had a space saver rough old wheel on.
Didn't take long and i made it out of some old aluminium plate that came off a milk float.
The welding is a bit rough....A few touchdowns
It's pretty much the same as ones you can buy. It's supposed to stop the cable that holds the wheel in place being cut and the wheel nicked.
I hadn't bothered before as it only had a space saver rough old wheel on.
Didn't take long and i made it out of some old aluminium plate that came off a milk float.
The welding is a bit rough....A few touchdowns
