scott_shot
Member
- Messages
- 119
I have a supermig 150/1 i done a euro conversion to about 6months + too and has been sweet up till now.
2 nights ago i was welding my buggy, Welders running sweet then when i let off the trigger gas was still flowing full pelt form the torch. I turned off the welder and the gas. Turned back on and had stopped =S anyway the next night i was using it again and no problems till much later that night and same thing happened except is stuck open now snd every time the welders on gas will be flowing out the torch.
My guess is its a stuck solenoid, i just wonder if anyone had had this prob with the solenoids in the conversions and if there worth replacing? also the only other thing it could be is the trigger but of course the wire would feed if that was the case? Any helps appreciated guys.
2 nights ago i was welding my buggy, Welders running sweet then when i let off the trigger gas was still flowing full pelt form the torch. I turned off the welder and the gas. Turned back on and had stopped =S anyway the next night i was using it again and no problems till much later that night and same thing happened except is stuck open now snd every time the welders on gas will be flowing out the torch.
My guess is its a stuck solenoid, i just wonder if anyone had had this prob with the solenoids in the conversions and if there worth replacing? also the only other thing it could be is the trigger but of course the wire would feed if that was the case? Any helps appreciated guys.