As per title, im a bit stuck
I have a door (mustang) which had a sideswipe crease right at the bottom, prob 7mm deep at worst point. The swage line above as per pic as you can see has a subtle curve inwards, whereas it should be very subtely outwards.
I hav straightend out the worst of the crease, such that im within a mm or so of the correct level evereywhere, but i was expecting (foolishly) the swage line to move back out once id pulled the dent out. But it didnt.
Any suggestions where i go from here greatly appreciated. Access from behind is very poor. Whilst i get a dolly to a small area of it, i cant see how it would be possible on all of it, even if i knew what i was doing!
Help!
Please ignore the sill! Thats previous american repair work. Repair being a loose description. Thats the next job!
I have a door (mustang) which had a sideswipe crease right at the bottom, prob 7mm deep at worst point. The swage line above as per pic as you can see has a subtle curve inwards, whereas it should be very subtely outwards.
I hav straightend out the worst of the crease, such that im within a mm or so of the correct level evereywhere, but i was expecting (foolishly) the swage line to move back out once id pulled the dent out. But it didnt.
Any suggestions where i go from here greatly appreciated. Access from behind is very poor. Whilst i get a dolly to a small area of it, i cant see how it would be possible on all of it, even if i knew what i was doing!
Help!
Please ignore the sill! Thats previous american repair work. Repair being a loose description. Thats the next job!