Missed a lot of these messages sorry. Im very close to bringing this project to market now.. got a batch made up so ive come back to read the advice
i was going for zinc dipping rather than hot gal because its not offen going to get wet. But zinc i think would last longer..
The other problem ive got is the casters will be welded on so that would add complication and maybe make it impossible.
If paints cheaper. Lower lead time. Keep it in house then thats they way ill go as it only need to look good for a few months.
The prototype as been run with bare metal for about 4 months and has hardly any rust on it atall.
Now its between brush. Roller or spray.
Thanks for all your help. Any idea what a spray set up for the 2 pack paint would cost... its faily small so wouldnt be like spraying a pannel on a car
i was going for zinc dipping rather than hot gal because its not offen going to get wet. But zinc i think would last longer..
The other problem ive got is the casters will be welded on so that would add complication and maybe make it impossible.
If paints cheaper. Lower lead time. Keep it in house then thats they way ill go as it only need to look good for a few months.
The prototype as been run with bare metal for about 4 months and has hardly any rust on it atall.
Now its between brush. Roller or spray.
Thanks for all your help. Any idea what a spray set up for the 2 pack paint would cost... its faily small so wouldnt be like spraying a pannel on a car