Curiousgeorge
Member
- Messages
- 265
- Location
- Wales
Hello.
When doing a stop/start, what is the best way to start off where you finished a weld? I always thought it was to start 2 mm away, briefly go back over where you finished and then move on again? (Also, I'm assuming that feathering the end of the weld first is advantageous?)
When doing a stop/start, what is the best way to start off where you finished a weld? I always thought it was to start 2 mm away, briefly go back over where you finished and then move on again? (Also, I'm assuming that feathering the end of the weld first is advantageous?)