DickyDoDah
Member
- Messages
- 261
- Location
- Witshire, UK
Hi all, I have a Stealth DIGI-MIG 200 LCD from SWP and would like to try the lift TIG function on it but I cannot find out the pinout of the 12 way connector for the torch. I did contact SWP directly and I was sent a pinout diagram but it wasn't for the Stealth DIGI-MIG 200 LCD. I'm not getting far with a new enquiry to them so thought I would ask here if anyone has one of these and has successfully used the TIG function. This is the connector which is an unusual type but they do include a plug for it in the box. I have looked at the back of the socket and found that only pins 1 to 8 are connected and I could tell where the spool gun connections went but all the others go to the control board and there are no hints on there of the functions.
