I'm sealing some vertical partition panels where they meet a corrugated roof and using gun grade squirty foam.
Now all the instructions say to hold the gun so that the can is vertical exit at the bottom, and of course this is needed so the the contents are forced out properly, but obviously not possible when at ceiling level. Now holding so that the can is horizontal is fine with a new full can but as soon as it empties a bit, neat propellant comes out and blasts the foam already squirted into oblivion.
Any suggestions?
Anyone used a pipe to extend the nozzle with any success?
Now all the instructions say to hold the gun so that the can is vertical exit at the bottom, and of course this is needed so the the contents are forced out properly, but obviously not possible when at ceiling level. Now holding so that the can is horizontal is fine with a new full can but as soon as it empties a bit, neat propellant comes out and blasts the foam already squirted into oblivion.
Any suggestions?
Anyone used a pipe to extend the nozzle with any success?