So i went in the internet and i found this.

[Robbie260]

http://www.langmuirsystems.com

Thought this may be of interest to you guys and girls cnc plasma cutting machine setup for less than a $1000 obviously american but maybe could be shipped to the uk or might be a starting point for someone looking to build thier own ideas wise.

Edit after looking its actually $1300

there is even some basic specs on this page down near the bottom http://www.langmuirsystems.com/crossfire

 

[Shedendman]

27 seconds in,yer carry on cutting that wood like that

 

[fizzy]

http://www.langmuirsystems.com

Thought this may be of interest to you guys and girls cnc plasma cutting machine setup for less than a $1000 obviously american but maybe could be shipped to the uk or might be a starting point for someone looking to build thier own ideas wise.

Edit after looking its actually $1300

there is even some basic specs on this page down near the bottom http://www.langmuirsystems.com/crossfire

I would love to build one - there are quite a few designs out there. I would rather a laser cutter but a decent one is £50k or more.
Looks like one of these will be on my project list - or perhaps a CNC router instead.

 

[eLuSiVeMiTe]

27 seconds in,yer carry on cutting that wood like that

Nope never...

Ok ok . Only for rough cuts and usually over my knee.

There's a good reason I use 4 trestles over two and break up sheet goods on a piece of scrap mdf

 

[Robbie260]

Have to admit usually these things are huge so they can at least fit a full sheet its the size that interests me the most.