Small pressure gauges

  1. Kram

    Kram Member

    Messages:
    1,783
    Location:
    Sussex
    Would like to get some small ones 0-60 psi with rear connection. I cant find much below 40mm/1.5". Are smaller ones available, 20-30mm?
    1/8" bsp is also large for where its going. M5 or similar would be ideal.

    Thanks
     
  2. Aff

    Aff Member

    Messages:
    126
    Location:
    Weymouth
    I have some nice Festo ones at work. Pretty sure they are rear M5 and about an inch diameter.

    Did you need just 1? If so I should be able to send you one.
     
    Kram likes this.
  3. The_Yellow_Ardvark

    The_Yellow_Ardvark perkele

    Messages:
    13,742
    Location:
    England
  4. Aff

    Aff Member

    Messages:
    126
    Location:
    Weymouth
  5. Kram

    Kram Member

    Messages:
    1,783
    Location:
    Sussex
    That would be great, how much do I owe you?
    Im after two although the second I can manage with a bigger type, Ive got a 40mm.

    Im no good with bar/kpa/mpa so the ebay one not ideal, otherwise looks good.
     
  6. Aff

    Aff Member

    Messages:
    126
    Location:
    Weymouth
    You'll have to wait until I'm in work at some point next week. I'll have a dig around in my drawers.
     
  7. Kram

    Kram Member

    Messages:
    1,783
    Location:
    Sussex
    Ive had a good look at the Festo site, they do make some tiny ones 15-27mm but the accuracy/design it wont be worth doing. Thanks for the suggestion I will keep looking.

    Had an idea though, I could use valve cap TPMS sensors and have the wireless display on the work bench. No idea how accurate they are but for the price I like the idea.

    They are to go on my air tools/spray guns
     
    ukracer likes this.
  8. mtt.tr

    mtt.tr Member

    Messages:
    4,052
    Essex England
    Cant have a wireless one? This is assuming space is the issue
     
  9. Kram

    Kram Member

    Messages:
    1,783
    Location:
    Sussex
  10. Shox Dr

    Shox Dr Chief Engineer to Carlos Fandango

    Messages:
    16,036
    Location:
    East Yorkshire
    I was looking for the very same while back. You will struggle to find smaller than 45mm dia for pressures below 100psi.
    I required 0-15, and 0-60psi.

    <20mm gauges are also known as pony gauges, but tend to be high pressure.
    Mc master in the states list 0-60
     
  11. selectedgrub

    selectedgrub Member

    Messages:
    1,495
    Location:
    New Zealand
    [​IMG]
     
  12. Lewis_RX8

    Lewis_RX8 Member

    Messages:
    469
    Location:
    Scotland
    Always found VDO gauges to been good quality, made in Germany.
     
  13. Kram

    Kram Member

    Messages:
    1,783
    Location:
    Sussex
    This arrived and looks like it will work well
    [​IMG]
    Except I cant see a way to disable the bleepy low pressure alarm.
    I will put an adaptor for it in my gf3 spray gun, need some dry weather to test.
     
Advertisements