Sip Turbo MIG 196

[JBGalway]

I am looking for someone that owns a SIP 196 MIG, I need photo's of the wiring, mainly the white wire from the PCB board - where does it connect too and the red & blue from the wire feed motor. Any help would be greatly appreciated.

 

[eddie49]

Maybe someone who owns one of those machines will reply.
If not, if you could post clear photos of both sides of the PCB, and identify where on the board those wires are connected, it should be possible to work out where those wires should go.

 

[skotl]

I am looking for someone that owns a SIP 196 MIG, I need photo's of the wiring, mainly the white wire from the PCB board - where does it connect too and the red & blue from the wire feed motor. Any help would be greatly appreciated.

Might be of use?

SIP Topmig Super 196 no wire feed, of course!

Hi all, I am new to the forum even though I have read posts in the past. I bought the Topmig 196 on ebay. It was listed as not working so I knew what I was getting into. When I collected it, the guy said the small transformer had gone. I replaced it but of course it didn't work. I get clicking...

www.mig-welding.co.uk