sip migmate 130 turbo

[darren817]

i have the above mention weapon and it has worked fine for a good ten years or so but now i have no wire feed, stripped the ****** and with plastic handled screw driver and wet finger tip discovered a fault in the wire feed pcb the magnetic relay works fine if i hold my finger on it, now im lost in a cavernous hole of elastic-trickery, googled the bit as a whole nicely marked 'mig 02 ipf' but to no avail any ideas on how to further check this bit or where i can buy a complete pcb all finished and polished, ta

 

[mike 109444]

Hellow Darren. Do you mean when you manualy operate the relay that the wire feed motor runs ? If you only suspect that the board is faulty there is the possibilty that the motor is faulty. To check/test disconnect the two wires going to the motor (noteing which connector is connected to which terminal as its a DC motor and will run backwards if wrong!) then connect a battery charger to the terminals on the motor, this should make the motor run.....?