stinkbridgenine
Member
- Messages
- 93
hi,i`ve got a sip topmig 150 (my own fault i suppose),and im having problems getting a decent weld flow due to continuos splatter/spitting.i`ve tried power+wire speed adjustment,wire seems to be flowing freely,checked for good earth (i.e clean metal)plenty of gas(co2).new reel of wire (0.8).the only thing i can see which does`nt look right is that the wire reel spins too freely(only learned this through reading a few posts on here)as there does`nt seem to be any securing mech. for the reel i.e.reel just sits on guide wheel! certainly not an expert at this welding lark,so any help v.much appreciated. i would like to try+sort this out rather than dive in+buy another welder,as it`s had very little use+given good results in the past.also is there any advantage to be got by fitting a eurotorch+conv. kit?: