Hey guys i have read a few of the sip 130 wire feed problems on here and im not sure if its the same problem.
Ok here is what happens pull the trigger and im getting a click from the inside of the circuit board but no feed. I rigged up a 12v feed to the motor from my car battery and it turns fine.
Also with handle, part of the metal contact from the trigger broke. it does contact fine (was working before the feed problem) but have to pull the triger in further. if i can sort out the power feed problem i will buy a new handle/gun any one know how i can sort this problem rather than buying a new welder.
its always the same get to near the end of the job and it stops. Grr lol
any help appreciated.
Ok here is what happens pull the trigger and im getting a click from the inside of the circuit board but no feed. I rigged up a 12v feed to the motor from my car battery and it turns fine.
Also with handle, part of the metal contact from the trigger broke. it does contact fine (was working before the feed problem) but have to pull the triger in further. if i can sort out the power feed problem i will buy a new handle/gun any one know how i can sort this problem rather than buying a new welder.
its always the same get to near the end of the job and it stops. Grr lol
any help appreciated.
