Sip 130 turbo part needed

[Slo]

Hi folks, My welder just died, it is a SIP 130 TURBO. Its the black transformer on the control board thats gone, had a multimeter on it and one side is open circuit. If I manually operate the relay the welder works as normal ie wire feed motor spins and transformer humms. Does anyone know if I can get a replacement transformer for the control board? I have no idea what voltage its kicks out but as far as i can tell its only for the wirefeed motor and relay. Could really do without having to buy a new welder and im right in the middle of a job and stuck.

Cheers Slo

 

[shenion]

See if you can make out the voltage on the relay; the transformer would bethe same voltage. I seem to recall others using a 24V transformer wired externally to the pads.

 

[Slo]

It says 12volt DC/16A 240volt on the relay it seems to be quite a comon circuit board in a lot of welders.
http://img.photobucket.com/albums/v322/Sloposse/Maxxd/DSC00121.jpg

 

[PaulMcElhinney]

I am in Birmingham. If you can't get it repaired you can borrow my SIP 130T to finish your job.

Rgds,

Paul McElhinney.