single stage regulator

[timmyw]

Hi, could someone please help. Have a new welder to set up and unsure what kg/cm2 it should be working at. Is a mig 180 amp and will be using 0.6 mm wire trying to weld around 2-3mm mild steal.

 

[mike 109444]

Welcome Tim. The flow rate for mig is usually quoted as "liters per minute" not sure if maybe your gauge may have a second set of figures on it? which might be the liters per min which is usually between 10 to 15 but don't know what it is for kg/cm2.
Can you post pic of gauge?

 

[mike 109444]

Just been googling for a converter table but I think the problem is that Kg/Cm2 is a measure of PRESSURE where as L/per min is a measure of FLOW !