Kram
Member
- Messages
- 6,235
- Location
- Sussex
Ive looked up the sizing for shrink/interference fits but its a bit more complicated than I thought.. Atleast in metric. For a 24mm shaft I think I want 0.054mm interference but the table did not give larger examples.
My shaft is 39.91mm and the hole is 39.81mm, both are steel. I dont have much depth of contact, and I would likely go oversize boring another pass...
If I heat the hole upto 300c and knock it in, will it go?
My shaft is 39.91mm and the hole is 39.81mm, both are steel. I dont have much depth of contact, and I would likely go oversize boring another pass...
If I heat the hole upto 300c and knock it in, will it go?