chrismac
Member
- Messages
- 396
- Location
- Highlands
I have a little sheldon lathe, I was hoping to turn a thread pitch of 4 1/2 but dont have the correct gears, anyone here have any ideas where I might get something to get me going, I have very little info at the moment apart from the bore of the gears, loads on ebay but all too big and not sure(doubt it very much) if a 24 tooth gear from a different machine would be the same OD,
here is an image of the thread/feed chart,
Untitled by chrismac2012, on Flickr
here is an image of the thread/feed chart,
Untitled by chrismac2012, on Flickr