Hi, I would just like to know the proper technique for fitting a collar/spigot on the round end of a square to round transition.
Ive made a square to round for a little project im working on, being a small transition of 100mm in height the angle of the fitting makes fitting a collar rather difficult. So im asking what is the correct way to do this.
One idea i have had was to allow a little bit extra on the round side (same as for the square side to allow lap for the next piece) and form it out after bending however wasnt sure how that would work out.
Just for a general idea of what im making, its 100mm high, 400 round by 300x200 and its offset approx 50mm. 0.55mm sheet
Thanks
Ive made a square to round for a little project im working on, being a small transition of 100mm in height the angle of the fitting makes fitting a collar rather difficult. So im asking what is the correct way to do this.
One idea i have had was to allow a little bit extra on the round side (same as for the square side to allow lap for the next piece) and form it out after bending however wasnt sure how that would work out.
Just for a general idea of what im making, its 100mm high, 400 round by 300x200 and its offset approx 50mm. 0.55mm sheet
Thanks