See plenty on ebay are they any good?? Not going to be used a lot just a few welding jobs on motors ..Been hoping to find a home made one on ebay but no luck..mostly for small lips on 1mm sheet
See plenty on ebay are they any good?? Not going to be used a lot just a few welding jobs on motors ..Been hoping to find a home made one on ebay but no luck..mostly for small lips on 1mm sheet
Dont waste your money, do a google for 'home made sheet metal folder' or something similar. There are plenty of plans out there for free that range in build cost from cheap to expensive. Clamps, some angle iron and a vise will usualy do everything you need without any fancy equipment. You dont need to spend a heap of money, a soft faced hammer or a slapper, a couple of bits of angle iron in a vice and you can bend pretty much anything you can in a factory made brake
i was looking at this, 28quid cant complain.
http://www.ebay.co.uk/itm/18-Metal-...ps=63&clkid=5495623579422885372#ht_1280wt_905
See plenty on ebay are they any good??