wristpin Member Messages 1,178 Feb 15, 2021 #1 There’s a guy on the Old Mower Club forum who’s sheared a cylinder block stud flush with the block and compounded his error by snapping an extractor in it. Does anyone know of somewhere in the Honiton area of Devon who might assist?
There’s a guy on the Old Mower Club forum who’s sheared a cylinder block stud flush with the block and compounded his error by snapping an extractor in it. Does anyone know of somewhere in the Honiton area of Devon who might assist?
JEZGUZ Member Messages 1,076 Feb 15, 2021 #2 A carbide burr in a die grinder or dremel and a steady hand works. I had the exact same problem and sorted it with a carbide burr.
A carbide burr in a die grinder or dremel and a steady hand works. I had the exact same problem and sorted it with a carbide burr.
