Section roller problem

[Brad93]

If you want to spend some money on it we could get it to my workshop and I would strip it down, repair/remanufacture anything required and build it back up. But obviously it depends what you want to spend.

Nothing is irreparable if it was made before 2000

 

[Thrashsmith]

If you want to spend some money on it we could get it to my workshop and I would strip it down, repair/remanufacture anything required and build it back up. But obviously it depends what you want to spend.

Nothing is irreparable if it was made before 2000

Cheers for the offer. I think I'll just go for something smaller & new. I got it for about £1000 a few years back & it's served me well, but the size of it has always bugged me as it's such a lump. If the head of it could flip horizontal then I'd definitely want to save it.
Want to buy a project?

 

[Brad93]

Cheers for the offer. I think I'll just go for something smaller & new. I got it for about £1000 a few years back & it's served me well, but the size of it has always bugged me as it's such a lump. If the head of it could flip horizontal then I'd definitely want to save it.
Want to buy a project?

No value to me other than scrap I'm afraid. Maybe someone else here fancies the challenge