nightjonboy
Member
- Messages
- 57
- Location
- Devon, UK
Howdy! Hope this is the correct place to put this thread!?
I’ve just spent about 2 hours setting up my new bandsaw and cannot get it to cut perfectly in the z plane.
I’ve adjusted the bearing holders to their maximum, as well as the bearings themselves which allowed me an extra couple of degrees closer to be being plumb. But it’s still about 1 or 2 degrees out even on a piece of 50mm tube. The cut is angled -2 degrees or so if facing the bandsaw with the blade in the down position.
I feel like I’ve exhausted ALL the possible adjustments. Can anyone suggest what I might be doing wrong?
I’ve just spent about 2 hours setting up my new bandsaw and cannot get it to cut perfectly in the z plane.
I’ve adjusted the bearing holders to their maximum, as well as the bearings themselves which allowed me an extra couple of degrees closer to be being plumb. But it’s still about 1 or 2 degrees out even on a piece of 50mm tube. The cut is angled -2 degrees or so if facing the bandsaw with the blade in the down position.
I feel like I’ve exhausted ALL the possible adjustments. Can anyone suggest what I might be doing wrong?