Run razor pictures wanted.

[ajlelectronics]

I repainted the 'bike panels today. All good bar one run which I will deal with next week. I know that I have a Run razor somewhere but naturally I will not be able to find it! Looking at adverts, they want silly money for them and there is no chance of me buying another!

If I could find some hi-res images, I could probably design one over the weekend and 3D print it. The sale adverts all have the same front view of the device and it would be useful to see more details of it.

 

[northwest]

HERE

 

[ajlelectronics]

Thanks kindly.

 

[Dcal]

Pictures?

 

[rcx132]

I just bought a Mirka tungsten block for cutting out runs. Will get to test it soon.

 

[ajlelectronics]

Pictures?

The job was done at the last minute today, so a quick inspection was all I had time for. The panels have been left in the workshop to harden over the weekend.

 

[RaceDiagnostics]

I used a run razor once then converted to a tungsten block, much better and easier to use. Would have sent you my old one if I could find it.

 

[jsf55]

I've used a scrapper blade with a bit of masking tape wrapped round the outer edges and the middle piece to scrape

 

[badabec]

Any good?

Razor Plane by GBernalCo

This is a razor plane for balsa wood, perfect for RC builders. It use standard razor blades and cut depth can be adjusted with the screw. I use a 2mm screw to attach the blade

www.thingiverse.com

or

Razor Planer for Balsa Wood by tauscnc

V2 Version here! https://www.thingiverse.com/thing:5277656Wanted a razor planer for my RC airplane build (downloaded one which looks similar but wanted fine adjustments on the blade like the Master Aircrew one you can buy without having to use a special blade). I made mine with top mounted hole...

www.thingiverse.com

or

Razor Plane By KAD by Kad370

Simple razor blade plane for balsa wood and other soft woods. I can be used for shave down leading and trailing edges, fuselages, wings and tails for free flight or RC planes.

www.thingiverse.com

or

Hand Planer by Biolook

A simple hand planer with 45 degree (which is rough, use it with soft materials) , pretty tight tolerance"0.1" clearance, using grease for the track and the screw is recommended, there is a 2mm hole (use filament piece or cut cloth hanger steal wire “27mm”) in the screw shaft to secure the...

www.thingiverse.com

 

[ajlelectronics]

Any good?

Very interesting! I am going to print a couple of them and see what they are like. My from scratch re-creation is still unfinished.