Yes they are for an S15. I need to make up 4 setsas has been said they are spherical bearings, quite often 'wide angle' ones you would want fluro-lined/ plastic lined ones over brass lined ones. if they have grease nipples on them then you don't want them. although those look like a metalastic bush pressed into a tube. which for a road car is better than a 'rose joint' as they don't get full of crud and wear out.
what are they for? a Nissan?
Non of those brings up what i need.
A couple are close but i need the name of the complete end with the bolt thread attached.
Sorry....
A couple are close but i need the name of the complete end with the bolt thread attached.
Sorry....
Yeah i am up with it being an adjustable control arm.
Its an adjustable control arm, it will have a left and right hand thread on the same bar, Bits from rally spares or here https://www.driftworks.com/adjustable-arms/
Cheers frank. See my other reply.Mr, UK racer, they won't have a different names just cos they have a welded on thread,........once u find a place that list's the above names Isolastic-Metalastic then u need to get to a sub heading for a better description........
this will also change due to thread dia's and type Metric, fine or cource plus UNF and C.......then length etc etc........it'll take a good man to know all the models........just give Quintin Hazel a try, they have shop/parts center's.......
on odd ball stuff like this check out parts in the USA, they are pretty good with descriptions and they deff give u a tracable part number's......
don't mean to vague but stuff like this, every dam Car Producer has their own style and usually not interchangable between models.......
TRY buyin ball joints for obsolete tractors.....hahaha......
Frank
Cheers frank. See my other reply.
Its the rod end that contains the isolastic bush i cant find for sale on their own....
Its not car specific just mounting specific ....but as i am making them i can adjust to suit.
Ah now that makes sense. I was wondering if that was the case Just seems strange that they dont sell them.....they sell everything else in china. LolYou buy tubing, cut it to length and weld it to a bolt to make the eye then find a bush to press into the tubing usually, they don't come ready made. If you get poly bushes and crush tubes you can make them to your own sizes to fit in most brackets. Nissan panhard rods used to have a left hand thread at one end and right hand at the other to give you easy length adjustment.